radio

poormansgs · Post by **poormansgs** » Thu Jul 19, 2007 7:57 pm

my BX14 has one of those plug in removable radios but it does not work.
Before i scrap the radio I need to check the wiring to it but as it is all "factory fitted and well and truly part of the loom" I cannot find which route the wiring takes before entering the back of the radio.
Any help would be welcome;
Regards
Geoff

M · Post by M » Thu Jul 19, 2007 8:47 pm

The radio wires whilst not ISO type simply plug into the back of the radio - when you remove it they will have some slack on them to allow you to pull them out and disconnect them.

Have you checked the fuse?

poormansgs · Post by **poormansgs** » Fri Jul 20, 2007 5:57 pm

not so Marty. the plug which entres the radio is actually fixed as part of the radio housing. It is a nice arrangement and plugs in nicely - but there is no slack and no way to access the wiring - other than completely dismantling the radio housing. any suggestions welcome;
Best regards
Geoff