TD clutch cable

Mothman · Post by **Mothman** » Mon Apr 16, 2012 12:17 pm

Hi, anyone got a TD clutch cable in reasonable nick? Need one asap.

Thanks
Andy

themildbunch · Post by **themildbunch** » Mon Apr 16, 2012 6:38 pm

Sorry, don't have a spare but if you find one can you share your experience of changing it - not a nice job I think...

Oilyspanner · Post by **Oilyspanner** » Mon Apr 16, 2012 6:52 pm

If its the one with a weight on the end and a black plastic bit where it fits into the gearbox end I have a good one.

Mothman · Post by **Mothman** » Mon Apr 16, 2012 7:09 pm

Not sure if its the one bud, ile check with citronut.

I gather its a bastard to fit but much easier if the engine is out which it is.

Andy

Oilyspanner · Post by **Oilyspanner** » Mon Apr 16, 2012 7:42 pm

Fitting should be a breeze with an empty engine bay

are you doing the octopus while the bay is empty, and the rubber pipe that goes onto the back of the water pump?
pm me an email address and I will send a picture of the cable, I am certain it is TZD
Stewart

citronut · Post by **citronut** » Mon Apr 16, 2012 10:35 pm

themildbunch wrote:Sorry, don't have a spare but if you find one can you share your experience of changing it - not a nice job I think...

two minutes if you have the engine and box remove

Oilyspanner/Stewart
pm sent

regards malcolm

citronut · Post by **citronut** » Tue Apr 17, 2012 1:15 pm

sorted thanks to GSF

thanks for the picy Stewart

although even with the engine and box out the tinny nylon ring that lock's the nylon feral into the pedel box bracket is a challenge

regards malcolm