Wanted radiator support panel..

Buy or sell parts etc. Please put 'Wanted' in the title if it is a request for parts.
tom
Citroen Sorceror
Posts: 1239
Joined: Fri May 20, 2005 8:51 pm
Location: straddling the channel

Wanted radiator support panel..

Post by tom » Sat Dec 16, 2006 6:50 pm

..for a TD. The black part that secures with five screws to the bonnet slam panel and carries the intake snorkel and bonnet stay clip.
Vive les UX.

User avatar
sleepy0905
1K Away
1K Away
Posts: 1394
Joined: Thu Aug 25, 2005 9:23 am
Location: Birchwood, Lincoln

Post by sleepy0905 » Sat Dec 16, 2006 7:12 pm

I dont know it helps but i have one of a 1.9 NA Diesel you can have for postage.
2014 Citroen C4 1.6 eHDI Selection Special edition 115Bhp

tom
Citroen Sorceror
Posts: 1239
Joined: Fri May 20, 2005 8:51 pm
Location: straddling the channel

Post by tom » Sat Dec 16, 2006 7:18 pm

Thank you for the kind offer Sleepy but the TD one is rather different, alas.
Vive les UX.

User avatar
sleepy0905
1K Away
1K Away
Posts: 1394
Joined: Thu Aug 25, 2005 9:23 am
Location: Birchwood, Lincoln

Post by sleepy0905 » Sat Dec 16, 2006 7:21 pm

Ok no problem
2014 Citroen C4 1.6 eHDI Selection Special edition 115Bhp

User avatar
ken newbold
Over 2k
Posts: 4408
Joined: Sun Aug 14, 2005 10:53 pm
x 5

Post by ken newbold » Sat Dec 16, 2006 7:25 pm

Mulley was also after one of these and after seeing his car today, I think he still is.
They think it's all over, it is now!

User avatar
Vanny
Merseyside resident
Merseyside resident
Posts: 3424
Joined: Tue May 17, 2005 11:48 pm
Location: BX Pub
My Cars: BX 16v Ph2
x 11

Post by Vanny » Sat Dec 16, 2006 9:35 pm

got one in the garage, will hunt it out tomorrow and bring it home

tom
Citroen Sorceror
Posts: 1239
Joined: Fri May 20, 2005 8:51 pm
Location: straddling the channel

Post by tom » Sun Dec 17, 2006 10:30 am

Bless you Vanny! Many Thanks! PM me an address so I can send you a postage token!
Vive les UX.

jeremy
Over 2k
Posts: 2112
Joined: Fri Jul 01, 2005 2:58 am
Location: Hampshire UK

Post by jeremy » Mon Dec 18, 2006 8:55 am

Hope you've found one Tom - If I had to make one I would use heavy re-inforced rubber sheeting - cut a strip to the correct width - then drill the appropriate holes in it and cut a slot or something for the air intake.

Rubber sheet could probably be obtained from Portmere Rubber which is near Freeborn.

Mine 's been split (for about 1 ft) ever since I've had the car but doesn't seem to be getting worse - but I suppose I ought to drill a hole to stop it getting worse.