Hello to all, Just out of interest I removed my rear bumper
there was a small amount of rust I say only small amount
got that sorted replacing bumper is easy only thing was
those blocks just fell off put them back on but don't
hold the bumper only thing holding the bumper on
is the bolts what do you guys do to get over this
leave it.
BX REAR BUMPER
-
- Over 2k
- Posts: 2695
- Joined: Sun Sep 02, 2012 9:54 pm
- Location: South Lincs
- My Cars: 90 Bx Tzd turbo ven red 295k
74 D Super 5 black
05 Volvo V50 2.0d 180k
65 Peugeot Boxer work van 280k - x 137
Re: BX REAR BUMPER
the blocks should be attached to the bumper (if they still clip in) first, then lift the bumper into place get one side in, make sure the slots in the square mounting lug fit into the body then push it forward about an inch it should slide into place and be tight to the body, it will be obvious if its in properly or not, then do other side, you will know if its right as the screw holes on top will be lined up, an assistant may help. it is not uncommon for the body to rust away and come away with the bumper around the mounts only to be told by removal of bumper, hopefully not the case.
90 BX Tzd turbo 294k SORN undergoing major surgery
90 BX Tzd turbo estate 46k awaiting surgery
65 Peugeot Boxer Van the new workhorse
52 Toyota Rav4 180k Bulletproof Jap reliability
90 BX Tzd turbo estate 46k awaiting surgery
65 Peugeot Boxer Van the new workhorse
52 Toyota Rav4 180k Bulletproof Jap reliability
Re: BX REAR BUMPER
if the general appearance of the original bumper is good,
i would remove it place the blocks into the slots they are supposed to lock into, if they will not lock into place as they are meant to, just fasten them in place with self tappers through the edges of the blocks, and into the lips of the bumper the blocks locate into
regards malcolm
i would remove it place the blocks into the slots they are supposed to lock into, if they will not lock into place as they are meant to, just fasten them in place with self tappers through the edges of the blocks, and into the lips of the bumper the blocks locate into
regards malcolm
curent ride
K reg BX 17TD TZD est
also own
K reg D special
no longer have
H reg CX saffari 2.5 TRI (now gone to Malaysia)
R reg xantia 1.9TD est (gone to meet its maker)
K reg BX 17TD TZD est
also own
K reg D special
no longer have
H reg CX saffari 2.5 TRI (now gone to Malaysia)
R reg xantia 1.9TD est (gone to meet its maker)
- greendale65
- BXpert
- Posts: 509
- Joined: Sun Mar 02, 2014 5:52 pm
- x 20
Re: BX REAR BUMPER
Good idea Malcolm, will be doing that got to keep
these things right rgds Alan.
these things right rgds Alan.