LHM drain or flush?

BX Tech talk
Post Reply
User avatar
Philip Chidlow
Over 2k
Posts: 11594
Joined: Fri Oct 07, 2005 1:08 pm
Location: Chelmsford, Essex
x 25

LHM drain or flush?

Post by Philip Chidlow »

My BXs LHM fluid seems a tad 'dirty' and I wondered if it really is necessary to drain the system and flush with Hydraurinçage (is that right?) etc. etc. as I've heard some folks do... Can I just drain the LHM - using a pump set up that I can borrow from my Citroen enthusiast neighbour - from the reservoir, then refill with new, clean LHM... Will I notice a difference?

Any advice welcome!
• 1992 Citroen BX TZD Turbo Hurricane
• 2006 Xsara Picasso 1.6 16v
Mr B
Northern Moderator
Northern Moderator
Posts: 710
Joined: Mon May 16, 2005 12:32 pm
Location: On a sofa, up the road from Marty!

Post by Mr B »

You need to remove the tank to drain the mucky LHM and clean the filters. Turn the steering full left hand lock, drop the suspension to low and release the pressure on the regulator. This will release as much LHM back to the tank as possible. Once all the cleaning has been done and you have pressure back in the system, bleed the brakes, as this will push clean LHM through.
1991 Landrover Discovery
1995 VW Golf SE
adamskibx
BXpert
Posts: 950
Joined: Fri Jul 22, 2005 9:26 pm

Post by adamskibx »

It seems like Mr B has given good advice. Regarding Hydraflush, ive no idea. My local Citroen specialist hates the stuff and says he would never dream of putting it in his BX, but the last BX I bought had hydraflush in it when I bought it and when I changed it back to LHM there were no problems. In fact i never had any problems full stop; But, if the height correctors are working as they should and your happy with the way the system is working at the moment, then a change to clean LHM and a filter clean, is probably the best option as it cant exactly do any harm, and is certainly better than noticably dirty LHM fluid.
User avatar
Philip Chidlow
Over 2k
Posts: 11594
Joined: Fri Oct 07, 2005 1:08 pm
Location: Chelmsford, Essex
x 25

Post by Philip Chidlow »

Thanks for the advice, chaps. I will get my hands dirty soon...
• 1992 Citroen BX TZD Turbo Hurricane
• 2006 Xsara Picasso 1.6 16v
AlanS
BXpert
Posts: 841
Joined: Mon May 16, 2005 9:53 pm
Location: Queensland, Australia

Post by AlanS »

2 little bits of advice; if you've never had your hand inside an LHM tank before, be extremely careful of the inside edge of the tank; razor blades come to mind. Real easy to cut yourself on it. Image

Secondly, do a brake bleed on all 4 wheels. Brakes are dead ends and the last car I did was my Xantia which up to that point hadn't been all that flash in the way it rode. When I bled the rear brakes, I managed to drain about 250mls of very frothy liquid out which started out gold colour and ended up the right shade of green and we've all lived happily ever after. :lol: :wink:


Alan S
By the time you're old enough to know it all, you can't remember why you were learning.
User avatar
Philip Chidlow
Over 2k
Posts: 11594
Joined: Fri Oct 07, 2005 1:08 pm
Location: Chelmsford, Essex
x 25

Post by Philip Chidlow »

Thanks for the tip, Alan.
• 1992 Citroen BX TZD Turbo Hurricane
• 2006 Xsara Picasso 1.6 16v
User avatar
Oscar
1K Away
Posts: 1091
Joined: Wed May 18, 2005 5:07 pm
Location: Driving a ZX

Post by Oscar »

Hydraflush is worth doing - it cleans all the crud and dirt out of your system. There is an opinion that it stirs up dirt and can lead to blockages, but I don't agree.

I did it with my BX and I was surprised at how dirty the H'flush was when it came out after 2000 miles.

O
(Red BX 1.7TZD ("Well, it is a style icon" - Tom Sheppard)) "Was", Tom, "was"
User avatar
mnde
Meteor Man
Posts: 1453
Joined: Tue Oct 18, 2005 5:10 pm
Location: Aldershot, Hants
My Cars: 2007 Citroen Xsara Picasso 1.6 16V VTX
1982 Citroen GSA Spécial Estate - gone to a new home
1991 Citroen BX16 TGS Meteor - still out there somewhere!

Post by mnde »

Like Mr B and Alan have said, it's a good idea to be thorough when you do this.

Definitely take the tank out. On the GSA I gave mine a good wash out with white spirit. Take the opportunity to clean off all the crud on the "lid" around the pipe connections and the level indicator. Wash the filters in white spirit then blow dry with an airline (or I've used a li-low footpump to good effect) and dry the inside of the tank using kitchen paper. The difficult thing is getting the lid back on without the large filter becoming unhooked and falling off inside. It's quite a tight fit. I've made the mistake of putting the tank back in the car before doing this.... and then repeatedly having to dip my hand into the clean LHM to fish out the pesky filter :x

I'd say, especially if you're refilling with Hydraflush, once you're all filled up (having primed the pump etc.) do an extended Citaerobics session, turn the wheel from lock to lock etc. to send the stuff round the whole system... THEN bleed all four brakes until you get clean bubble-free fluid coming through. I guess if you wanted, you could take the lid off again and re-check the filters from time to time during the next 2000 miles to see if the Hydraflush has picked up anything on its voyages...

Mark.
Stewart (oily!)
1K Away
Posts: 1604
Joined: Wed May 18, 2005 6:23 pm
Location: North Wales

Post by Stewart (oily!) »

I have a spare tank and set of filters, I clean them and just swap them over, hydraflush did get a lot of clag out of the system which seems to be gone now (I had the tank off to weld the inner wing and the filters were still clean)
TZD 19 TD one of the few
Xantia Td estate, going soft
silverfox
Confirmed BX'er
Posts: 62
Joined: Wed Jan 04, 2006 4:01 pm
Location: North Wales Coast

Post by silverfox »

Stewart (oily!) wrote:I have a spare tank and set of filters, I clean them and just swap them over, hydraflush did get a lot of clag out of the system which seems to be gone now (I had the tank off to weld the inner wing and the filters were still clean)
I agree it HAS to be done - leave it too long and you'll have a nasty surprise when the steering feels as if its going to lock! I know - it happened to me! Hydraflush worked almost instantly - still got it in - 2,000 more miles to go before replacing.

Thanks for the tip about having a spare reservoir and filters Stewart - great idea! Geoff
Me depressed? Don't make me laugh!
User avatar
Philip Chidlow
Over 2k
Posts: 11594
Joined: Fri Oct 07, 2005 1:08 pm
Location: Chelmsford, Essex
x 25

Post by Philip Chidlow »

Excellent advise, lads. I will try and get hold of a spare reservoir and filters etc - not least because it would allow me to see how it all fits together etc. An super idea.
• 1992 Citroen BX TZD Turbo Hurricane
• 2006 Xsara Picasso 1.6 16v
silverfox
Confirmed BX'er
Posts: 62
Joined: Wed Jan 04, 2006 4:01 pm
Location: North Wales Coast

Post by silverfox »

I find the filters really fiddly when repositioning - also cut my finger first time! Yes is razor sharp Stewart! Is there an easy way/tool to reposition the filters? They are so easy to displace! Need smaller hands - and no wife to badger into doing it for me! :lol:

Also the system seems to take forever to re-pressurise afterwards - I tried the usual steering wheel both ways but still took ages. Priming the pump was difficult maybe I did it wrong? (I removed the supply pipe and primed it with LHM but probably got some air into it!) Geoff
Me depressed? Don't make me laugh!
User avatar
Way2go
Over 2k
Posts: 7279
Joined: Fri Jan 13, 2006 3:15 pm
Location: RCoBerkshire
x 2

Post by Way2go »

silverfox wrote:Also the system seems to take forever to re-pressurise afterwards - I tried the usual steering wheel both ways but still took ages.
There is a component that fails if you operate the power steering without power with the wheels on the ground. That is the rubber flexible coupling to the steering rack and can split. I found this out at a previous MOT time. :(
1991 BX19GTi Auto
User avatar
Oscar
1K Away
Posts: 1091
Joined: Wed May 18, 2005 5:07 pm
Location: Driving a ZX

Post by Oscar »

"There is a component that fails if you operate the power steering without power with the wheels on the ground. That is the rubber flexible coupling to the steering rack"

Oh. :( Mine has never had PAS and rebuilding the pinion valve is one of those jobs on the long finger at the moment. This piece of information might move it up the priority list.
(Red BX 1.7TZD ("Well, it is a style icon" - Tom Sheppard)) "Was", Tom, "was"
User avatar
(CZ)enda
Confirmed BX'er
Posts: 39
Joined: Sun Nov 06, 2005 11:15 pm
Location: Pilsen, CZ

Post by (CZ)enda »

Do you mean the Hardy joint - the rubber disc? It is not as bad as it seems, it was the first (of many) things I had to fix on my BX. But, it may be I had to saw the old one off :?:
Hydraurincage worked wonders. At least, it made the points that needed proper repair obvious :shock:
The nastiest surprise (the dreaded green puddle below rear axle) actually came before I used the hydraflush.
Post Reply