I have an old BX (1986) with a 150C engine that is almost dead, can I replace it by the newer post 1988 version (K1G)? What would I need to replace?
Thanks In advance
JT
K1G / 150C engine Interchangeability
Front subframe (!)
Weld on a new type engine support (car's) LHS inner wing top at strut.
Engine
Air filter box & ducting
Coolant hosing
Gearbox
Driveaxles
Hydraulic pump
Hydraulic main (rigid steel) pipe pump to PR
Hydraulic feed (rigid steel) pipe PR to safety valve
BTW its the same job whatever engine you decide to put in there instead of the type 150 ...
My advice : find a good 150 engine from a BX/Peug205
Weld on a new type engine support (car's) LHS inner wing top at strut.
Engine
Air filter box & ducting
Coolant hosing
Gearbox
Driveaxles
Hydraulic pump
Hydraulic main (rigid steel) pipe pump to PR
Hydraulic feed (rigid steel) pipe PR to safety valve
BTW its the same job whatever engine you decide to put in there instead of the type 150 ...
My advice : find a good 150 engine from a BX/Peug205
C U / Anders - '90red16riBreak - '91GrisDolment16meteor - Project'88red19trsBreak
dead cars : '89white 16RS - '89antrasitTRDturboEst - '90white19triBreak
dead cars : '89white 16RS - '89antrasitTRDturboEst - '90white19triBreak