Looking for a few little finishing bits for my silver valver -
Rubber o type ignition barrel trim.
The 2 self gripping screw plates that slot onto the metalwork behind the top part of the steering column shroud that the 2 TX5 screws go into.
Lower gear level gaiter, holed is fine so long as it is whole and not badly gashed.
Thanks
Couple of common bits needed
- Tim Leech
- Over 2k
- Posts: 15565
- Joined: Tue Apr 15, 2008 11:12 am
- Location: Derbyshire
- My Cars: Various
- x 141
Re: Couple of common bits needed
I know Barry has these as he is breaking a couple of BX's!
Lots of Motors, mostly semi broken....
Re: Couple of common bits needed
Thanks Tim I need to go see him when he is all settled in but if anyone ha sthem and cna pop thme i the post even betteTim Leech wrote:I know Barry has these as he is breaking a couple of BX's!