Hi. Does the TRD hatchback have a lift pump or a strainer in the fuel tank? Mine runs on jerry
can but not from the tsnk.
Jack
Fuel supply
-
- Confirmed BX'er
- Posts: 37
- Joined: Wed Jan 27, 2021 2:18 pm
- Location: Auch France
- My Cars: Citroen Bx 1.9d, Volvo 360, MB 206, Mitsy L200.
-
- 1K Away
- Posts: 1940
- Joined: Tue Jul 05, 2005 7:54 am
- Location: Usually in the garage
- My Cars: BX GTi, C3 Auto
- x 88
Re: Fuel supply
There is no lift pump on the BX fuel is effectively sucked out of the tank by the injector pump.
You have probably got an air leak between the tank and pump. Usual causes are the metal fuel supply pipe rusting through, it only need a tiny pin prick to stop the fuel so that you will not see any leak but the pump suction will draw in air. The fuel priming pump also perishes and fails.
There is a strainer in the tank pickup which could conceivably be bunged up if the tank is contaminated with something. This is easy to check. But I would have expected poor running as it got clogged up before the current complete failure.
Hope that helps and you get ti sorted quickly.
You have probably got an air leak between the tank and pump. Usual causes are the metal fuel supply pipe rusting through, it only need a tiny pin prick to stop the fuel so that you will not see any leak but the pump suction will draw in air. The fuel priming pump also perishes and fails.
There is a strainer in the tank pickup which could conceivably be bunged up if the tank is contaminated with something. This is easy to check. But I would have expected poor running as it got clogged up before the current complete failure.
Hope that helps and you get ti sorted quickly.
The Joy of BX with just one Citroën BX to my name now. Will I sing Bye Bye to my GTI or will it be Till death us do part.
-
- Confirmed BX'er
- Posts: 37
- Joined: Wed Jan 27, 2021 2:18 pm
- Location: Auch France
- My Cars: Citroen Bx 1.9d, Volvo 360, MB 206, Mitsy L200.
Re: Fuel supply
Yes, very helpful. Can you service the priming pump?
-
- BXpert
- Posts: 681
- Joined: Sat Sep 12, 2020 4:04 pm
- Location: Sayalonga, Malaga
- My Cars: 1992 BX19D Millesime
- LHD, NA, AC, RP_5800
1996 XM 2.5TD Exclusive - x 73
Re: Fuel supply
If it's a Purflux filter/primer (small black priming knob on top (but not angled), deep aluminium filter bowl), it also contains a pair of small non-return valves on the input side, and a small bronze micro-filter of the output side. These bits are under the input and output banjo bolts. If disassembling, make a sketch of the position of the parts, and get their orientation.
As Jaba says, the Purflux rubber priming diaphragm can split/perforate. The priming valve is available as a Purflux spare part (from good motor factors), so you don't need to replace the whole filter.
As a rough check for a blockage in the fuel line, try blowing down it (from engine end), and check whether there's bubbling in the tank.
Check the action of the priming pump/filter by disconnecting its output, and operating the primer. It should deliver squirts of non-aerated fuel.
As Jaba says, the Purflux rubber priming diaphragm can split/perforate. The priming valve is available as a Purflux spare part (from good motor factors), so you don't need to replace the whole filter.
As a rough check for a blockage in the fuel line, try blowing down it (from engine end), and check whether there's bubbling in the tank.
Check the action of the priming pump/filter by disconnecting its output, and operating the primer. It should deliver squirts of non-aerated fuel.
Chris
-
- Confirmed BX'er
- Posts: 37
- Joined: Wed Jan 27, 2021 2:18 pm
- Location: Auch France
- My Cars: Citroen Bx 1.9d, Volvo 360, MB 206, Mitsy L200.
Re: Fuel supply
Im on to it tomorrow.
-
- Over 2k
- Posts: 2695
- Joined: Sun Sep 02, 2012 9:54 pm
- Location: South Lincs
- My Cars: 90 Bx Tzd turbo ven red 295k
74 D Super 5 black
05 Volvo V50 2.0d 180k
65 Peugeot Boxer work van 280k - x 138
Re: Fuel supply
You can use 10mm & 8mm copper pipe to replace the steel fuel lines, as they are no longer available from Citroen or £100 from Chevronics I would also recommend chenging all the rubber fuel lines up front whilst your at it. The purflux filters can be a bit temperamental esp the o ring seals so bypass it using an inline filter instead on the supply and return lines, use the squeezy pump to prime,
Your local plumbing shop should have the copper pipe for about £15. Use double wall 8mm fuel line think about 12ft does the lot, new clips jobs a gooden.
Your local plumbing shop should have the copper pipe for about £15. Use double wall 8mm fuel line think about 12ft does the lot, new clips jobs a gooden.
90 BX Tzd turbo 294k SORN undergoing major surgery
90 BX Tzd turbo estate 46k awaiting surgery
65 Peugeot Boxer Van the new workhorse
52 Toyota Rav4 180k Bulletproof Jap reliability
90 BX Tzd turbo estate 46k awaiting surgery
65 Peugeot Boxer Van the new workhorse
52 Toyota Rav4 180k Bulletproof Jap reliability
-
- Confirmed BX'er
- Posts: 37
- Joined: Wed Jan 27, 2021 2:18 pm
- Location: Auch France
- My Cars: Citroen Bx 1.9d, Volvo 360, MB 206, Mitsy L200.
Re: Fuel supply
How do you access the fuel tank connections?
-
- Over 2k
- Posts: 2695
- Joined: Sun Sep 02, 2012 9:54 pm
- Location: South Lincs
- My Cars: 90 Bx Tzd turbo ven red 295k
74 D Super 5 black
05 Volvo V50 2.0d 180k
65 Peugeot Boxer work van 280k - x 138
Re: Fuel supply
Under the back seat.
90 BX Tzd turbo 294k SORN undergoing major surgery
90 BX Tzd turbo estate 46k awaiting surgery
65 Peugeot Boxer Van the new workhorse
52 Toyota Rav4 180k Bulletproof Jap reliability
90 BX Tzd turbo estate 46k awaiting surgery
65 Peugeot Boxer Van the new workhorse
52 Toyota Rav4 180k Bulletproof Jap reliability