Looking for parts!!!!!

Anything about BXs
Post Reply
Paris
New Member
Posts: 12
Joined: Thu Oct 06, 2005 4:51 pm

Looking for parts!!!!!

Post by Paris »

right i am finding it really hard to find an exaust for my bx any answers?

its a 1.4

and a white bonnet
Grace
Confirmed BX'er
Posts: 46
Joined: Tue Oct 04, 2005 6:32 pm
Location: South London

Post by Grace »

Check the for sale/wanted area. :wink:
M

Post by M »

Any autofactor worth his salt should be able to source you one. You can check factors like GSF (www.gsfcarparts.com) and have a look on line - but any branch of National etc will be able to get you one in to fit - they aint obsolete.

Otherwise break out the coke cans, jubilee clips and gun gum....
User avatar
cavmad
Keeper of the site Goat
Posts: 7857
Joined: Fri May 20, 2005 9:13 am
x 1
Contact:

Post by cavmad »

As regards the white bonnet Vanny may have one for you.
Vauxhall apologist.
Stewart (oily!)
1K Away
Posts: 1604
Joined: Wed May 18, 2005 6:23 pm
Location: North Wales

Post by Stewart (oily!) »

There are at least two bonnet types, theres the "long nose" type or the "short Nose" GTIs and TZDs have the short nose ones which show off a little of the black grille .
Stewart
TZD 19 TD one of the few
Xantia Td estate, going soft
Kitch
Over 2k
Posts: 6417
Joined: Sun Jul 03, 2005 9:36 pm
Location: Fareham, Hants
My Cars: Too many to list
x 88
Contact:

Post by Kitch »

I imagine he's after an A/M one to make some noise.

No such luck fella, they don't make one for the sleeve jointed 1400's. The flange jointed bigger diameter cars have a Sebring box available and I believe Scorpion and Devil also cater.

No good to you however. Only route is getting one made, and thats pricey.
One third of a three-spoke BX columnist team for the Citroenian magazine.

CCC BX registrar: The national BX register - click to submit a car!

1983(A) 16TRS (Rouge Valleunga)
1990(H) 16Valve (Rouge Furio)
User avatar
Cornishbx16v
BXpert
Posts: 403
Joined: Wed Oct 05, 2005 3:41 pm
Location: Cornwall
Contact:

Post by Cornishbx16v »

if it is a full system he is after as kitch mentioned then i would say look for a powerflow agent as they will make one to your spec! although it normally costs around £350 for a full system (stainless)
Timmo.

After all I AM CORNISH!!!!

www.bx16v.com
www.bx16v.co.uk/forum
www.bx16valve.co.uk
Post Reply