I am about to fit my new heater matrix, to those of you who have done this: Is there a gasket between the oblong flange and the water valve?
I will need to get all parts ready before I start.
Stewart
Reloading my Matrix other parts needed?
-
- 1K Away
- Posts: 1604
- Joined: Wed May 18, 2005 6:23 pm
- Location: North Wales
Reloading my Matrix other parts needed?
TZD 19 TD one of the few
Xantia Td estate, going soft
Xantia Td estate, going soft
- ken newbold
- Over 2k
- Posts: 4408
- Joined: Sun Aug 14, 2005 10:53 pm
- x 5
-
- 1K Away
- Posts: 1604
- Joined: Wed May 18, 2005 6:23 pm
- Location: North Wales
-
- BXpert
- Posts: 605
- Joined: Sat Sep 24, 2005 4:10 pm
- Location: Marshfield in the cotswolds ...
- Contact:
No gasket, there are flat surfaced rubber rings recessed into area around the two holes in the valve bit. Although it doesn't appear that it will seal, when I reassembled there were no leaks
Marty said: "Take some small comfort from the fact that the driver of the other car, having failed the breath test will even now be in a little cell, with luck they will double him up with some mean bastard who will be tattooing a fandango on his arse"
'94 XM 2.1TD Break
'99 Xantia 1.9TD Break (almost there)
'63 Renault Caravelle
'94 XM 2.1TD Break
'99 Xantia 1.9TD Break (almost there)
'63 Renault Caravelle