Mate fitted a CD player to my TZD estate recently. Chuffed to bits as it was free from a scrapper and a nice bit of kit. BUT...since he`s wired it in...
Last post
Me too, though some stereos draw enough current to flatten the battery in a couple of days when on standby. Best to check it and listen for a slow...
Just need someone to confirm I'm not mental really....
As you may or may not know, Saxos have an electric power steering pump, rather than a belt...
Last post
Def a Saxo pump - it was a couple of years ago though. I'm sure I found a post on the Saxo list on Yahoo about doing it - but didn't turn it up on a...
No rude comments please, any ideas on common faults for this?
Cheers
N
Last post
Its possibly corrosion on the connectors to the horn unit itself - these are in the nearside front wing behind the bumper - and difficult to get at....
Good morning! Hope you all had a good weekend (was nice to meet you, Mr Bandit). I need to fit the towbar that was with my car when I bought it, and...
I have a 1.9 D and there are a few CLONKING noises when i first touch the brake pedal. I have had it checked out and it appears that there is wear on...
Last post
First of all, are the Calipers the Girling type?
Loads of ZX 19D's had seized caliper problems, and clonks even when the car was quite new, and lots...
hello
Has anyone had experience in a tzi that, on a fairly regularly basis blowing fuse number 1. This one covers oil pressure, tacho and air con...
Last post
Yeah, I'd go with that, had the same issue a few years back, the ribbon cable had been rubbing on the plastic trim that sits on the rear valance and...
Hi Folks,
I'm new-ish to BX ownership, and enjoying it so far... I note comments elsewhere that it pays to keep an eye on the cooling system, so I...
Last post
My TZD has only 82k on the clock (plus a full citroen service histroy... :-)). The message is clear from all and sundry - I must make sure the system...
This Saturday, I changed the cam-belt, changed the oil/filter, drained the coolant, and refilled with new. I did my best to bleed the cooling system...
Last post
Blimey - sounds like this coolant bleeding business is a bit of an acquired skill - lets hope I've caught it all before the heat has done for my...
Time to pick the brains as the car is undergoing its pre winter (yes I said winter as the South island got ravaged by some low level snow) make sure...
Last post
I think the problem with using an old type charger on a calcium battery is that it'll work too well and destroy the plates.
A local bodger (read garage owner) tried to convince me that Citroens intervals for changing the cambelt were rubbish
and that it could be left...
Last post
Have just read a couple of other posts about tensioners and spring-pressure, so unless you guys feel you have anything new you think I ought to know,...
Does it mean anything when the level indicator goes right up to the top of the plastic dome and stays there when the car is on and off? Is it just...
Last post
I was slightly worried by Sally's apparently high LHM level - I thought it couldn't possibly be that high and that there must be something wrong with...
When we get a diesel auto for the missus i'd like to try and convert 'Elf' to a manual and rebuild the engine at the same time. I've always loved the...
Last post
Ian, I did this conversion on my GTi a few years ago now. It was well worth doing. You will need a new clutch cable as well as the other bits...
Right its not a bx but I have an AX that had a very very bad rummble that went throught the whole car when you turned right at anything over 20Mph so...
Last post
Hopefully u can find the problem & get it sorted, nothing like the satisfaction of fixing something yourself rather than paying a garage.
Mine doesnt work although I have replaced the non ABS driveshaft with a correct one (thanks Ian), the ABS light went out once for about 2 seconds a...
Last post
Thanks matey, cars in tomorrow having the welding done and the other driveshaft fitted, will have a looky while its up on the ramps to see if theres...
...hi will be trying to remove the last few salvegable parts from the TZD hatch this afters. Can someone please explain in layman`s terms how to...
Last post
If you're in a position to pipe-clip, then the rear arms can come off pretty easily if you have a 24mm ring spanner, a 24mm socket and a breaker bar....
Here's a posting I made on another forum. Long winded admittedly, but has some info that might save someone the frustrations I've had in recent years...
Last post
Hi Alan,
I put that hychill minus30 in my car about 6 months ago now and it's fantastic. I didn't know about it until my local auto electrician that...
What differences are there (apart from the obvious hydraulic ones) between the BX and ZX 1.6 XU/B2C engine?
I.e. would it be possible for me to get...
Last post
Yep, the eBay Meteor is my daily driver while the GSA is having its cabin water leaks sorted @ Chevronics following its MOT, which it sailed straight...
I hope this does not sound too helpless but I cannot find the engine number on my TZD - I need it to complete an export certificate for the DVLA, and...
Last post
The engine number is on the right hand side of the block on a little riveted on plate it is not a huge number i think it is about 5 numbers long also...
..excuse me if this sounds a strange question but it is a genuine one. Can someone please tell m the exact length of a TZD estate backbox from where...
Last post
Count yourself lucky Billy, I had a VERY narrow escape a while back. That would have really bu&&ered up the time I get to spend on cars and...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum