For my mid term I need to totally recondition an engine of my Choice for the Engine rebuilding course I am on but I have ran into a couple of head...
Last post
I must admit I am surprised that you have had no luck with Euro Car Parts/GSF, I wonder if it is a problem with the knowledge of the member of staff...
Tonight some police officer pulled me to tell me I had no fog lights in the fog, think he was bored had a look and he was correct no fog lights...
Last post
No charge at the light socket: Charge at the fuse and no continuety at the fuse or light socket I have 4 green ones one blue one and one White one in...
Are most of the original hose clips on the BX 19 Engines either Clic or Clic R or some other kind of Jubilee style clip ? I need to remove a couple...
Last post
Yep got the top one done and fitted a standard Jubilee clip have to remove the starter motor guard to get to the bottom one for now I have fitted two...
a happy new year everyone !
I had a fair share of similar starter problems in the past. Eventually I realised that all I have to do is following the...
Last post
hi there
forgive me cos i havent read the whole thread incase someone else has already suggested this... but the click you get could be from the...
Anyone know how I can fix the rubber hose from the oil filler to the block ? Noticed its got a slit around 1cm in it and Citroen no longer have them...
Last post
I had a similar problem to this on my last-but-one TZD: on that car most of the rubber piping that could perish seemed to do so.
My GTi's oil guage has a mind of its own ie when I turn the ignition on the guage will read variable positions on each turn.
One of my tutors at...
Last post
Well my 19TZS and TRS have both got Oil Gauges fitted and to be honest I dont take notice of it prefering to check the traditional manual way of the...
Appears to be a Haynes 1 spanner job but is it straightforward swap or should I be watching out for anything untoward? Picked up a new one today and...
I'm wondering how easy it would be to swap the two stalks over - so the headlights/indicators/horn are on the right...I much prefer that layout as it...
Last post
It is a French car, you are expected to change gear with your right hand!
This reminded me how, driving on a clifftop road on a Greek Island, I...
As I said in the subject line, I was wondering if the long and short nose bonnets are interchangable. I have a rusty steel bonnet on my TGD and want...
Last post
There IS a small but important way in which steel and plastic bonnets are different.
I can't remember which way round it is but one type (plastic, I...
hello, I'm new to this site, I own a Bx tzd hatchback, which over the years has taken more abuse than israel. anyway I changed the spheres on the...
Last post
You need to remove the LHM pump feed pipe from the reservoir and fill the pipe manually, then quickly re- attach it to the reservoir with the engine...
Today was nice and sunny so I decided to get out there and take my intercooler off, with hope that I would uncover something really obvious relating...
Last post
David I carried out the test and I'm pretty sure I posted results, the pipe is blowing air, just a bit more than a hair dryer. Doesn't feel like...
Well, I have owned by BX TZD estate for almost 6-years and she has covered 140,000 miles. Aside from normal servicing, she has not required too much...
Last post
Dragging this old thread up again as it sounds very similer to the problem I am having.
Only differance being I replaced the Pressure Regulator as...
Hi all,
i see lots of exhaust systems on ebay but i will soon need a new exhaust system for my 93 Bx Estate. Can a forum expert give me the part nos...
Last post
Thanks Al and Ellevie,
you have given me all the info i need and am very grateful.
Whilst I have no doubt they are still available.....has anyone got any part number? Any make will do Quinten Hazel etc? I can cross reference. I...
Last post
Yes i did, i picked them up at the National last year courtesy of a mate of Simonbx17 from memory? Need to fit one of them to my txd as one side has...
I want to get all the lower wishbone suspension bushes on my car replaced, right side is clonking taking up drive and braking, pretty sure its them,...
Last post
ah the reassuring voice of someone who cares
..as in the garage didn't sound too keen..
Thanks David thats good to know. Did you have to be careful...
Garage informed me they wouldn't contemplate this because apart from the obvious, the hydraulic piping wouldn't fit between the turbo diesel innards...
Last post
Thing is, an original proper valver would be worth less with a diesel engine fitted. It's not a clever financial move, and it would be better to get...
Sorry to be such a newbie not knowing which pipe to check, is this the one:
If it's the wrong pipe then this was for nothing but I did take the...
Last post
Also, 1.9TD BX's where all fitted with the same turbo, the totally non existent turbo, there is no such thing as a factory BX with a XUD9T engine. I...
I heard that a good way to tell how well a BXs suspension has been looked after is to see how smoothly it rises and descends. Is this true and if it...
Last post
Hmm, not sure really as my first BX was also a Mk1 '84 but my Xantia of course, did have rubber bushes. I found the Xantia to have pretty crisp...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
