Encountered a clutch problem! Its be going on a few months now but it hit the head tonight. Difficulty in engaging gear in fact tonight it suddenly...
Last post
Should have posted, i have a spare new Valeo release bearing for that type. No use to me as wrong type for the release mechanisms I have. Would have...
I'm looking at some aftermarket alloy wheels for my BX19TGD Estate. The wheels are 7.0x17 ET25 4x108. If I was to fit these with 195/40/17...
Last post
I've tried switching wheels from the originals on my 16v, and I've gone back to the OE ones every time. There's no point being different for the sake...
I stop my valver after a long drive. Then it will not start again. Hot engine equals incomplete action from the starter.Key turns and produces all...
Last post
I am fairly sure I've nailed my beast - coil to distributor HT lead. Not that old, and I do change them about every 25k. Anyway when I inspected all...
The damaged p2 16v I recently got has a p1 hatch on it. I have the damaged p2 hatch and the wing is damage free
How easy is it to swap over with the...
Last post
Hair dryer, flat blade screwdrivers, a couple of people to hold the tailgate whilst its off the car & then at least one person holding the hair dryer...
Hi Folks
I need to replace most of (or all) of my dash bulbs. I can get as far as removing the two screws above the steering fairing and the two wing...
Last post
Thanks for the input chaps. The new bulbs arrived today so maybe have a go over the weekend.
Watch this space
Regards. Mike.
I was parked on my drive at a slight angle and the front suspension didn't rise for the first time the other day (the rear was fine). After I...
Last post
Heavy steering can be tracking - the front tyre wear should be pretty much dead even around the centre of the tyre if it is correct. The other thing...
Probably and hopefuly something very simple but I put one valver in for an MOT and I knew it had a couple of jobs one of which was the passenger side...
Last post
Thanks for the tips and I forgot all about the hazaed unit must check that when I go back up to the garage, that would be a nice fix
I'm looking for the topic about lubing the front struts. had a good look around on here...
Last post
I followed the advice given on the Australian BX forum, which mentioned sucking LHM into the struts by the return pipe, but also, with the suspension...
To add to the lively debate on air in the system, here's another oddity (to me).
The power steering on my tzd offers what could best be described as...
Last post
It is not necessary to replace the accumulator sphere unless the 'tick' time interval has diminished to an unacceptable level.
Yes, I know, but I have a legitimate reason....
I'm about to add GTi instruments to one of the TZDs so I can see proper temperature and pressure info...
Last post
One those tasks that is actually quite simple just made more difficult by the ones that want it to be that way. The BX speedometer drums are quite...
My BX GTI has two wires connected to the positive battery terminal, with in-line 15-amp blade fuses. Both wires go through the firewall; one powers...
Last post
Most aftermarket alarms take power from after the fuse box so that they can sense the voltage drop when a door is opened and the interior light goes...
Fun today, replaced a front brake flexy, no problem, old one off sweetly. Fit new one but can't get a good seal on the caliper end. Turns out it is a...
Last post
Unfortunately the scabby replacement pipe has knackered the caliper, zero chance of seal even though you can get a good pipe to go tight.
So moral is...
After springing a leak in a pipe a week ago, I've done what appears to be a good repair using layers of epoxy steel and aluminium mesh. I had lost a...
Last post
The weird spring thing is there to soak up vibration and allow movement of the engine, when ordering a new one it must be the same length as the o/e...
Someone must have had this. When I turn on the lights, usually the 4 console switches glow dimly. However the side light warning light on the dash...
Last post
Yes, the dim dip does not work, has not since car got rear sub frame mount welded. Now the side lights 5w ones do not come on either so I'll have to...
Tearing my hair out over this one, so hoping someone can give me some useful advice on here. The car is a 1993 BX with the naturally...
Last post
Just to resurrect this thread for the record. I just changed the o-ring around the white thermostat valve in order to cure a dribble from it and what...
One of the last jobs to complete the rebuild of the t/d is setting up the front brake calipers and new handbrake cables...i believe there is a...
Last post
Good, glad it's working OK. Only other thing to note is that the later hand brake cables have PTFE coated cables which do not freeze in position with...
1989 Bx estate with power.....I got fluid leaking from around the spindle..... As in where the column enters the steering rack.....firstly I believe...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum