As Jon has recently found out to his cost, the Tizzydee, being hairier than your average BX tends to suffer from furballs in the radiator over time....
Last post
Anders - I'm sure the problem with re-coring is the problem between an aluminium radiator and a traditionsl one with brass header tanks and a copper...
got a BX from my cousin and it runs very well for it's age. A few problems though.... i need to get the cigarette lighter out to replace it and while...
Last post
it's done.... have replaced the cig lighter (can now recharge my TomTom) and have punched in the code for the radio (again with the help from great...
I have so far replaced the cigarette lighter (so I can power the Tomtom). I noticed that one of the iluminator lights under the fan/temp control was...
Basically I need to fabricate an inlet manifold gasket (not for BX). Its for the AX GT and the gaskets don't come in the head set. I'm having trouble...
I have just been to fill up. And as i went to put the nozzel back in the pump there was the metal ring on it that has come adrift from the car. This...
Last post
BOLLOCKS!
Been away for the weekend, i have one of these in the garage that i paid £8 for but its neither use nor ornament as i have the magic long...
i cannot turn the fan control around to close the flap . As i cannot get the air to come through even with the fan at maximum, is it possible for the...
Last post
I understood that mechanics working on french cars were a special breed with extra joints in their arms - which was why they charged so much.
Ok I'm back again.. the cigarette lighter replacement is slightly different than the original. Instead of having a shared EARTH with the body of the...
Last post
thats what i thought. The light has it's own power supply (red wire) and the power to the lighter is via the plug. I only have to share a common...
Is it REALLY possible to change the timing belt on a TZD WITH THE ENGINE STILL IN THE CAR; Im having some real difficulty here, locating the locking...
Last post
I used a 8mm drill, it was a bit fiddly to reach behind the starter but possible. My biggest problem was the crankshaft pulley bolt which took 2 of...
Hey peeps! been out to cure my squeeking suspension issues i noticed the other day and found this!
now i have managed to bend the bar back to as...
Last post
i thank you! will do so! gsf have the parts too under investigation but dont have the lock pin! using pr.net looks like in total it should be £20.57...
Just noticed how worryingly low the tread on my front left tyre has become, and the other Michelin MXV's that I reckon are original are looking a bit...
Last post
I have to say that all the BX`s I`ve owned
That must be most of the ones still in existence...
Sorry it`s not BX related but I desperately need to grease the kingpins on my (Mercedes 609D) recovery truck. Sleepy has kindly pointed out where the...
Last post
I always noticed a real difference in the ADO16 / Mini / Metro / Marina when I greased the nipples - esp the fronts - I also took to injecting oil...
how DO you get at the two a side fixing bolts to remove the spoiler.
Taking the black plastic cover off reveals a very solid looking cover each side....
I took my GTi auto in for some work on the ABS and whilst there checked all the fluid levels. Rather alarmingly I found the dipstick on the auto box...
Just broken the flaming key in the ignition of the TXD hatch. Have a spare one here with key though (and wiring if needed). My question is to get the...
Last post
Torx is the new world - not for the old mad in a cave Billy 8)
Just got my car back from the garage, where I have two splendid new rear arm bearings, and a bit of...
Last post
For 165 tyres I'd go Michelin if at all possible, though appreciate they're not cheap. Offers are the best route. AFAIR Klebers are budget Michelins...
I reckon the Morette`s on my estate are the dog`s danglies BUT.... I reckon they`d look better if they all lit up on low beam. Currently they only...
Last post
Sounds like a lot of expense when all you need to do is change the bulb in the inner lamps like Billy first mentioned.
Regs permitting of course all...
Ive put in the heater matrix off the donor car- I took the original one out, filled it with water and it leaked at the passenger side end, so it was...
Just noticed the other day that when I open the bonnet with the engine running, the most significant clattering is coming from the HP pump. It sounds...
Last post
Bugger indeed!!! :twisted:
I hope not! I will get a powerful torch and a mirror and check that tomorrow. It would have to be the corner on the...
I need to touch up some marks (about the size of a 2 pence ) on my metallic paint. These were, apparently, the results of bird shit left on too long...
Last post
I believe red oxide primer is very good, followed by `normal` primer. I`d personally be tempted to get an aerosol matched up by Halfrauds or similar...
Right can anyone help i have followed the instructions on the rbsmith site including the oddity of L becoming O and O becoming L but i cannot get it...
Last post
Sleepy, as you say, you must be doing something wrong.
I have never done this myself but I do know that if Bob Smith has put his name to this...
Hi there, just looking for some info, i'm currently bidding and winning the Black TZD on Ebay, just checked and the seller has said the sppeedo went...
Last post
Never had the pleasure but I would imagine the speedo binicle has to come out along with the tray in the top of the dash and the glovebox. Then...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum